Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Company in Everett, WA
Gate repair in Everett comes down to two forces this city can’t avoid: salt air and rain. Properties within a mile of Port Gardner Bay get a steady dose of marine corrosion that eats hinges and latches faster than inland Snohomish County ever sees. Mix that with thousands of 1950s and 60s homes built during the Boeing boom, and you get a lot of original steel and chain-link gates now rusting through their second half-century. We work on them every week. Call (828) 426-7081 and you’ll get a written price before any work starts.
Why Everett Homes Are Different
Everett’s older housing stock is unlike what you’ll find in newer Snohomish County developments. The neighborhoods around Casino Road, View Ridge, and the Lowell area are thick with post-WWII tract homes built fast for Boeing workers. Their gates were often chain-link on steel posts set in shallow concrete, and the posts in low-lying areas near the Snohomish River delta sit in saturated glacial till. We regularly reset posts in Everett that have heaved or tilted within a few years of installation. It’s a soil condition, not a workmanship issue, and it means post re-setting is one of our most common repeat calls here.
Climate matters too. Everett averages about 38 inches of rain a year, and the humidity rarely lets up. Wooden gate boards swell in winter and bind against the frame. Steel hardware rusts. And within a mile of the Port of Everett, salt-laden marine air visibly pits hinge pins and latch mechanisms in a way you don’t see even a few miles inland. A gate that swings freely in August can be seized by January. We plan for that when we choose hardware for Everett repairs.
Our Main Everett Services
Most Everett calls to us fall into three buckets: a gate that won’t swing or slide right, an electric opener that stopped responding, or a motor that runs but won’t move the gate. Each has its own dedicated page below.
Gate Repair in Everett
A sagging, dragging, or seized gate in Everett usually traces to rusted hinges, swollen wood, or a post that’s moved. We see all three constantly, especially on the older chain-link and ornamental steel gates built in the 1950s and 60s. Salt air near the bay accelerates hinge wear, and wet winters make wooden gates bind. We remove the gate, replace worn hardware with corrosion-resistant parts, re-set posts when needed, and hang everything back so it swings true. Full details, including what a post re-set involves in Everett’s low-lying soil, are on the Gate Repair in Everett page.
Electric Gate Repair in Everett
When an electric gate opens partway, beeps without moving, or won’t respond to a remote, the cause is usually in the opener unit, the safety sensors, or the wiring feeding them. Everett’s damp climate shortens the life of exposed wiring and sensor housings, and salt air near the water makes corroded connections more likely. We test the full circuit before replacing anything, and we stock parts for the major opener brands so most electric gate jobs are done in one visit. Read specifics on the Electric Gate Repair in Everett page.
Gate Motor Repair in Everett
The gate motor, the box that slides or swings your gate automatically, takes the brunt of Everett’s weather. Moisture intrusion is the top killer of gate motors here, whether it’s condensation inside the housing or rain working past a worn seal. We test the motor, the capacitor, the limit switches, and the gear assembly before recommending a repair or replacement. When a motor is beyond saving, we quote the replacement before ordering anything. The Gate Motor Repair in Everett page covers the full diagnostic process and motor replacement pricing.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in Everett
We service equipment from Linear, Viking, Ghost Controls, and DoorKing, along with five other major gate and opener brands. We keep common parts for these systems in our local stock, which means most Everett repairs don’t wait on a shipment. See the full list on our brands page.
Pricing for Gate Company in Everett, WA
| Service | Typical range in Everett |
|---|---|
| Gate hinge replacement | $180 – $320 |
| Gate post re-setting (single post) | $350 – $650 |
| Steel gate weld repair | $220 – $480 |
| Chain-link gate replacement (standard single) | $450 – $900 |
| Gate opener diagnostic | $95 – $180 |
| Opener control board replacement | $300 – $650 |
| Gate motor replacement | $750 – $1,700 |
| Remote or keypad replacement | $90 – $220 |
| Safety sensor replacement | $150 – $350 |
| Gate wheel or roller replacement | $150 – $300 |
What pushes a job toward the high end in Everett is usually salt-air corrosion. Heavily pitted steel, rusted-through latch boxes, or posts so far gone that the footing has to be dug out entirely take more time than a clean pull-and-swap. Whatever the job, your written price is quoted and agreed before any work starts. No surprise line items at the end.
Neighborhoods We Serve in Everett
We run jobs across Everett every week, from the older craftsman-era blocks near downtown and Lowell to the mid-century tract neighborhoods around Casino Road, View Ridge, and Silver Lake. We also cover the commercial gates along the port-adjacent corridors. Typical response time for scheduled repairs in Everett is 24 to 48 hours, and emergency calls are dispatched same day when a tech is available.
- Downtown Everett
- Lowell
- View Ridge
- Silver Lake
- Casino Road corridor
Service Area – Cities Near Everett
In addition to Everett, we serve the surrounding Snohomish County communities. If you’re just north of the city line, our Marysville, WA page covers service there. East of Everett, see Lake Stevens, WA and Snohomish, WA. South along the Sound, we handle Mukilteo, WA as well.
Serving Everett, WA - Our Local Coverage Area
We’re based in the Everett area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Everett
Emergency calls in Everett are dispatched same day when a technician is available. Scheduled repairs are typically booked within 24 to 48 hours. Call (828) 426-7081 and a live person answers 24/7, so you’ll know exactly when someone is coming.
Most repairs and replacements of existing gates in Everett don’t require a permit. New gate installations with new footings or electrical runs may, depending on scope and location. We’ll tell you before quoting if your job appears to need one, and estimates are always free.
Yes, every time. The written price is given to you before any work begins, and it’s the price you pay. We don’t add surprise line items at the end. If a repair fails within 365 days, the return visit is free under our Done Right Promise. Call (828) 426-7081 for a free estimate.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Everett Customers Say
"Fair price and no pushing a whole new gate when all I needed was a new motor capacitor."
- Shirley A."The vetted tech thing was important since our gate protects the whole property. Careful, polite, and walked me through every safety sensor."
- Russell W."Swing gate wouldn't latch after the hinge sagged. He re-hung it, adjusted the hinge pins, and fixed the latch. Quoted before starting."
- Annette R.