Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Company in Big Bear Lake, CA
Gate repair in Big Bear Lake is not the same job as gate repair down the mountain. At 6,752 feet, with 60-plus inches of snow each winter and hard freeze-thaw cycles all spring, gates up here fail differently than anywhere else in Southern California. Posts heave out of plumb, wood panels split under snow load, and automatic openers that work fine in Redlands shut down at 20 degrees. If you’re looking for a gate company in Big Bear Lake that understands these conditions before the first phone call, you’ve found us. Call (828) 426-7081 and we’ll answer in person.
Why Big Bear Lake Homes Are Different
Big Bear Lake’s housing stock is mostly 1950s through 1980s A-frame cabins and log-style vacation homes, and most of them now operate as short-term rentals. That matters for gate work in two ways. First, wood privacy gates are everywhere, chosen to match the cabin look, but at this elevation wood absorbs snowmelt, swells, freezes, and splits faster than wood at sea level. We routinely replace hinge stiles that have cracked clean through after two or three winters.
Second, the owners are often 90 minutes away in the LA basin. A gate that stops opening is not noticed until the next guest checks in and cannot get their car in. That turns what would be a routine repair in the valley into an emergency call timed around a Friday turnover. We plan our Big Bear Lake routes around exactly that pattern, and we keep the parts that fail most in this climate on the truck, not back at a warehouse.
Frost heave in the mountain soil is the one condition no flatland gate company plans for. By spring, 4×4 and 6×6 posts that were plumb in October are leaning, latches no longer line up, and automatic gates bind on their tracks or reverse on the safety sensors. Fixing the gate without addressing the frost-heaved post means you’ll call again next May. We address both.
Our Main Big Bear Lake Services
Most Big Bear Lake calls we get come down to one of three problems: a gate that will not open or close, an automatic opener that stopped responding, or a motor (the box that slides or swings your gate automatically) that’s making noise but not moving anything. Each has its own page here.
Gate Repair in Big Bear Lake
Gate repair here usually means a wood gate that’s dropped, a post that’s moved, a latch that no longer catches, or hardware that’s failed after heavy snow. At Big Bear Lake elevation, hinge screws work loose in swollen wood and bottom rails rot from standing snow. We repair the gate in place when we can, replace hardware with galvanized or stainless where the climate demands it, and re-set posts properly when frost heave is the real culprit. See how we handle it on our Gate Repair in Big Bear Lake page.
Electric Gate Repair in Big Bear Lake
Electric gate repair in Big Bear Lake has a cold-weather side that flatland service calls never see. Battery backup units, standard on automatic openers down the hill, drain rapidly in sub-freezing temperatures. Safety sensors get buried in snowbanks and fault out. Control boards contract and crack solder joints. We troubleshoot the complete system, not just the visible symptom, and we carry the cold-rated parts that keep opening and closing through January. Read more at Electric Gate Repair in Big Bear Lake.
Gate Motor Repair in Big Bear Lake
A gate motor in Big Bear Lake works against ice, snow load, and a gate that’s heavier than it was when installed because the wood has absorbed moisture. When the motor strains, it burns out limit switches and strips gears. We replace motors, rebuild gearboxes where the brand allows it, and recalibrate open and close limits for the actual weight of your gate today, not the weight from the original install. Details on our Gate Motor Repair in Big Bear Lake page.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in Big Bear Lake
We’re factory-trained on Viking, Ghost Controls, DoorKing, and Elite, along with five other major gate and opener brands. That means we arrive with the right replacement parts for your specific opener in the truck, which matters in Big Bear Lake where the nearest parts counter is an hour down the mountain. For the full list, see our brands.
Pricing for Gate Company in Big Bear Lake, CA
| Service | Typical range in Big Bear Lake |
|---|---|
| Gate repair service call | $89 – $145 |
| Gate hinge replacement | $150 – $350 |
| Gate latch or lock replacement | $120 – $280 |
| Post re-setting (frost heave) | $250 – $600 |
| Wood picket or panel replacement | $30 – $90 per picket |
| Electric gate troubleshooting | $120 – $240 |
| Gate motor replacement | $600 – $1,800 |
| Control board replacement | $275 – $650 |
| Safety sensor replacement | $95 – $225 |
| Battery backup replacement | $180 – $450 |
| Full gate system inspection | $150 – $300 |
Mountain pricing runs higher than valley pricing for one reason: travel. We schedule Big Bear Lake routes to keep that cost predictable, but it’s built into every quote we give. Whatever the number, it’s the number you’ll see in writing before any work starts, and it’s the number you’ll pay when the job is done.
Neighborhoods We Serve in Big Bear Lake
We handle gate work across the Big Bear Lake area, from the lakefront strips to the higher-elevation streets where snow sticks around longest. Our techs know which neighborhoods frost heave hardest and which gates face the worst snow drift.
- Eagle Point
- Fawnskin (north shore)
- Boulder Bay
- Moonridge
- Big Bear Boulevard corridor
We typically respond to Big Bear Lake calls on the same day when they come in before early afternoon, and we batch runs to keep the trip charge fair.
Service Area – Cities Near Big Bear Lake
Our gate repair coverage extends beyond Big Bear Lake proper. We also serve Big Bear City, CA just east of the lake, Running Springs, CA down the front grade toward the valley, Lucerne Valley, CA on the desert side, and Mentone, CA where the mountain meets the I-10 corridor. If your property is near any of those, we can route a tech your way.
Serving Big Bear Lake, CA - Our Local Coverage Area
We’re based in the Big Bear Lake area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Big Bear Lake
We answer the phone live 24/7 at (828) 426-7081. For weekday calls, we can usually get a tech to Big Bear Lake the same day. For STR turnover emergencies, tell us your guest check-in time when you call and we’ll schedule around it. Weekends follow a route that already covers mountain properties.
That depends on the property. Some Big Bear Lake HOAs require specific gate styles or heights, and certain lakefront lots carry additional setback rules. We don’t pull permits ourselves, but we’ll flag what we see and recommend a check with your HOA before major changes like a full gate replacement or an opener swap to a new power run.
Yes, that’s the majority of our Big Bear Lake work from November through April. Frozen hinges, posts heaved out of plumb, motors laboring under snowbound gates, dead battery backups. Call (828) 426-7081 and describe what the gate is doing. We’ll give you a straight answer on what it likely is, and a written price before anyone touches your gate.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Big Bear Lake Customers Say
"Fair price and no pushing a whole new gate when all I needed was a new motor capacitor."
- Shirley A."The vetted tech thing was important since our gate protects the whole property. Careful, polite, and walked me through every safety sensor."
- Russell W."Swing gate wouldn't latch after the hinge sagged. He re-hung it, adjusted the hinge pins, and fixed the latch. Quoted before starting."
- Annette R.