Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Company in San Fernando, CA
Gate repair in San Fernando means working on homes built tight to the lot line, where the driveway gate is often the only thing between the street and the front door. Most of the gates we service here are ornamental wrought iron swing gates installed between the 1970s and 1990s, and they carry decades of Valley heat and Santa Ana wind in their hinges and welds. Whether it’s a gate motor that quit or a frame torqued off its post, we send a named, photo-badged technician with a written price before any work begins. Call (828) 426-7081 any hour for a live person.
Why San Fernando Homes Are Different
San Fernando is its own city, fully surrounded by Los Angeles but governed by its own rules. That matters for gate work because permits and inspections run through San Fernando’s Community Development Department, not LADBS. A company permitted only through LA City cannot legally pull the permit your gate job may need, so it’s worth asking before you book.
The housing stock is mostly single-family bungalows and small ranches from the 1940s through the early 1970s, on narrow lots where the driveway gate is the primary security barrier. Many of those gates are original ornamental wrought iron, some hand-welded decades ago, and they’ve spent forty or fifty summers thermal cycling in the San Fernando Valley heat dome. That repeated expansion and contraction loosens hinge pins, cracks welds at the stress points, and warps frames just enough to make the gate drag or refuse to close.
Santa Ana wind events funnel straight through the valley and hit older swing gates especially hard. Gates on single-post strap hinges get blown fully open or torqued off the post overnight, and on a narrow San Fernando driveway a downed gate blocks the car completely. Those calls can’t wait.
Our Main San Fernando Services
San Fernando homeowners call us most about two things: gates that won’t open or close, and the motors that power them. Each service has its own San Fernando page with full pricing and a dedicated FAQ.
Gate Repair in San Fernando
Most gate repair here means rebuilding what heat and wind have worked loose: hinge pins, weld cracks, sagging frames, binding latch posts. On older ornamental iron, the original welds were often done by hand and have never been touched since installation. We straighten, weld, and rehang so the gate swings clean and latches positively, and we quote the written price before any work starts. See the full breakdown on our Gate Repair in San Fernando page.
Electric Gate Repair in San Fernando
Electric gate repair in San Fernando is usually about the control board, the safety sensors, or the wiring between them, and Valley heat accelerates every one of those failures. When a board cooks in an afternoon hot enough to soften the enclosure, the gate stops responding and the manual release becomes the only way in. Our technicians diagnose the fault on site and carry the common FAAC, BFT, and Linear parts on the truck so the gate is back in service the same day. Details and exact pricing are on our Electric Gate Repair in San Fernando page.
Gate Motor Repair in San Fernando
The gate motor, the box that slides or swings your gate automatically, works hardest in San Fernando’s summer. Thermal expansion binds slide tracks and makes the motor draw excess current until the overload trips or the gear strips. Whether it’s a swing arm, a slide operator, or an underground unit on a Viking or BFT setup, we bench-test the motor and replace what failed rather than selling a new one by default. Full service specifics are on our Gate Motor Repair in San Fernando page.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in San Fernando
We service FAAC, BFT, Linear, and Viking equipment, among others, and our San Fernando trucks carry the control boards, remotes, and safety edges those brands use most. That means most motor and openers jobs are completed the same visit rather than waiting on parts. See our brands for the full supported list.
Pricing for Gate Company in San Fernando, CA
| Service | Typical range in San Fernando |
|---|---|
| Gate hinge replacement (wrought iron, welded) | $180 – $340 |
| Weld repair to cracked gate frame or post | $150 – $300 per weld point |
| Gate frame straightening (Santa Ana torque damage) | $220 – $450 |
| Latch and receiver rebuild | $120 – $220 |
| Gate motor replacement (swing arm) | $650 – $1,200 |
| Gate motor replacement (slide operator) | $900 – $1,600 |
| Control board replacement (FAAC/BFT/Linear) | $280 – $650 |
| Safety sensor or photo eye replacement | $150 – $300 |
| Full electric gate service call with diagnosis | $95 – $145 |
| Remote transmitter programming (per remote) | $45 – $90 |
What pushes a San Fernando quote higher is usually age rather than complexity: gates installed in the 1970s and 1980s often need multiple hinge rebuilds and a weld point or two in the same visit, and slide tracks on narrow driveways sometimes require concrete work to remount properly. Whatever the total, the price is written down and agreed before we start, and it does not change at the end.
Neighborhoods We Serve in San Fernando
We cover every residential neighborhood in San Fernando, including the areas around the downtown corridor and the older bungalow blocks east of Truman Street. Response time across the city is generally the same day for repairs, and emergency Santa Ana damage calls are triaged first because a downed gate on a narrow driveway means no car gets out.
- San Fernando downtown corridor
- Aurora Vista area
- East San Fernando (east of Truman)
- Maclay School district neighborhoods
- South San Fernando (near Pacoima Wash)
Service Area – Cities Near San Fernando
While this page covers San Fernando, our crews work throughout the northeast Valley and adjacent Santa Clarita corridor. If you live just outside the city, your gate repair may be covered from the same dispatch desk, so check the page for your area: Burbank, CA, Santa Clarita, CA, Glendale, CA, and Stevenson Ranch, CA.
Serving San Fernando, CA - Our Local Coverage Area
We’re based in the San Fernando area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Gate Company in San Fernando
Most San Fernando repair calls are same-day, and we have technicians positioned across the Valley so drive time stays short. Emergency calls, especially Santa Ana wind damage that leaves a gate blocking a driveway, are triaged ahead of scheduled work. Call (828) 426-7081 and you’ll speak to a person, not a recording, who can tell you the next available slot.
San Fernando runs its own Community Development Department, separate from LADBS. Structural gate replacement and some automation work can require a city permit, and we confirm that before quoting so you aren’t surprised later. The price you’re quoted includes any permitting we coordinate on your behalf.
Yes. You’ll know the technician’s name and see their photo before they arrive, and they’ll show a photo ID badge at the door, every time. It’s part of the Threshold Standard, the vetting and badging process every Warden tech goes through before they ever step onto your San Fernando property. Call (828) 426-7081 to set a window that works for you, and we’ll honor it.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What San Fernando Customers Say
"Fair price and no pushing a whole new gate when all I needed was a new motor capacitor."
- Shirley A."The vetted tech thing was important since our gate protects the whole property. Careful, polite, and walked me through every safety sensor."
- Russell W."Swing gate wouldn't latch after the hinge sagged. He re-hung it, adjusted the hinge pins, and fixed the latch. Quoted before starting."
- Annette R.