Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Company in Mount Vernon, NY
Gate repair in Mount Vernon almost always means working on pre-war iron and steel on lots where a few inches of clearance decide whether the gate opens at all. Most of our calls are for original pedestrian and driveway gates from the 1910s through the 1940s, set in concrete footings poured a century ago and squeezed between attached rowhouses. We send a named, photo-badged technician with a written price before any work starts. If your gate is dragging, sagging, or refusing to latch, call (828) 426-7081 and we’ll walk through what you’re seeing.
Why Mount Vernon Homes Are Different
Mount Vernon’s housing stock is dominated by attached and semi-attached two- and three-family rowhouses built primarily between 1900 and 1940. These homes sit on tight urban lots that function as a northern extension of the Bronx, and their gates reflect that. We regularly work on original ornamental iron pedestrian gates and narrow single-car driveway gates with corroded cast hinges, deteriorated welds, and posts anchored in crumbling mortar or frost-heaved concrete.
The climate does not help. Mount Vernon takes the full Northeast freeze-thaw cycle, and the road salt spread across its dense street grid from November through March gets kicked up and caked onto gate hardware. Repeated frost heave in the clay-heavy soils of southern Westchester is the main reason posts lean and gates stop swinging freely. On the tightly packed blocks near the Bronx border, driveway openings frequently measure only 8 to 10 feet wide, so a gate that has sagged just a couple of inches off level will drag on the apron. That job usually requires resetting the post in new concrete, not just adjusting a hinge, because there is no room to compensate with a wider swing arc.
Long story short: Mount Vernon gate work is urban pre-war work. The gates are heavy, the clearances are tight, and the original hardware is usually still in place. That changes how we diagnose, what we stock, and how long a repair takes.
Our Main Mount Vernon Services
Most Mount Vernon homeowners call us for one of three problems: a gate that will not open or close, a gate opener that stopped responding, or a gate motor that is making noise but not moving the gate. Each service has its own Mount Vernon page with local pricing and specifics.
Gate Repair in Mount Vernon
Gate repair in Mount Vernon is usually structural. We are resetting leaning posts, cutting out and replacing rusted cast hinges, repairing cracked welds, and re-hanging original iron gates that previous owners never maintained. On narrow rowhouse lots, a gate that will not latch leaves a clear sightline from the street to a front door that sits only a few feet back. We quote the full repair in writing before work begins, and the 365-Day Done Right Promise covers a free return visit if the fix fails. Full details: Gate Repair in Mount Vernon.
Electric Gate Repair in Mount Vernon
Electric gate repair in Mount Vernon often comes down to wiring that has been in the ground since the Clinton administration and safety edges that no longer register. On pre-war properties, the power run to the gate is frequently spliced, under-gauge, or chewed through. We diagnose opener faults, replace loop detectors, repair photo eyes and safety edges, and get the gate opening from the keypad and remote again. See what a repair involves: Electric Gate Repair in Mount Vernon.
Gate Motor Repair in Mount Vernon
Gate motor repair in Mount Vernon means diagnosing the box that slides or swings your gate automatically before condemning it. We service Linear, Viking, Ghost Controls, and DoorKing motors, among others. In this city, salt and freeze-thaw cycles shorten capacitor and control board life, so we stock the common replacement parts for faster turnaround. If the motor is humming but the gate is not moving, call before you keep pressing the remote. Details: Gate Motor Repair in Mount Vernon.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in Mount Vernon
We are factory-trained on nine gate and opener brands, and the ones we see most often in Mount Vernon are Linear, Viking, Ghost Controls, and DoorKing. We stock common boards, capacitors, limit switches, and remote receivers locally so most opener and motor repairs finish in one visit. See our brands for the full list.
Pricing for Gate Company in Mount Vernon, NY
| Service | Typical range in Mount Vernon |
|---|---|
| Gate post reset (swing gate) | $300 – $650 |
| Hinge replacement (cast iron or weld-on) | $180 – $400 |
| Weld repair (cracked frame or picket) | $150 – $375 |
| Gate re-hang and realignment | $250 – $500 |
| Gate opener diagnostic fee (applied to repair) | $79 – $125 |
| Control board replacement | $275 – $600 |
| Limit switch adjustment or replacement | $125 – $250 |
| Safety edge or photo eye replacement | $180 – $400 |
| Gate motor replacement (swing or slide) | $650 – $1,400 |
| Full swing gate installation | $2,400 – $5,500 |
| Full slide gate installation | $3,000 – $6,500 |
In Mount Vernon, the big price driver is the original footing. When a pre-war post has to come out of century-old concrete and go back into a fresh pour, the job is dig-and-set work, not a hinge tweak. Tight lots with no side clearance can add time too, because every panel and tool has to come through the house or alley. Whatever the number, you get it in writing before any work starts, and that written price does not change at the end.
Neighborhoods We Serve in Mount Vernon
We take gate repair calls across every part of Mount Vernon, from the Bronx-border blocks south of Sanford Boulevard up through the North Side and Fleetwood. Most of our Mount Vernon calls are scheduled within 48 hours, and emergency gate-down situations are prioritized the same day.
- Fleetwood
- North Side
- South Side
- Chester Heights
- Oakwood Heights
Service Area – Cities Near Mount Vernon
Beyond Mount Vernon, our crews cover the surrounding Westchester and Bronx border area, including New Rochelle, NY, Yonkers, NY, Bronx, NY, and White Plains, NY. Scheduling is coordinated from our New York City office, and your technician arrives with a name, a photo, and a written price.
Serving Mount Vernon, NY - Our Local Coverage Area
We’re based in the Mount Vernon area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Mount Vernon
Most Mount Vernon gate repairs are scheduled within 48 hours. If the gate will not close and your property is unsecured, we treat it as an emergency and prioritize same-day dispatch when a technician is available. Call (828) 426-7081 and we will tell you the next open slot right on the phone.
Repairs to an existing gate do not require a permit in Mount Vernon. Full replacements, especially if a new footing is poured or the driveway opening changes size, may require a building permit. We will confirm the specific requirement for your block before any work starts, and the price is agreed in writing first.
Every repair is covered by the 365-Day Done Right Promise. If the same problem returns within a year, we come back at no charge and make it right. Call (828) 426-7081 and reference the job number on your written quote.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Mount Vernon Customers Say
"Fair price and no pushing a whole new gate when all I needed was a new motor capacitor."
- Shirley A."The vetted tech thing was important since our gate protects the whole property. Careful, polite, and walked me through every safety sensor."
- Russell W."Swing gate wouldn't latch after the hinge sagged. He re-hung it, adjusted the hinge pins, and fixed the latch. Quoted before starting."
- Annette R.